Deanne Fields Base Cabinets January 06th, 2018 - 14:37:02
But what do you do when you are fitting cabinets between two walls? Well in this case the cabinet dealer can supply you with filler pieces to take up any large gaps that will eventually occur by using cabinets that are built within 2 inch increments. These cabinet filler pieces can be cut to fit the remaining gap relatively well. The main disadvantage with stock kitchen cabinets is the aforementioned incremental sizing but also the quality. Although as with anything the lower to mid range priced stock cabinets are typically made from thinner materials and have economy hardware such as cabinet door hinges and drawer slides. There are a few advantages with using stock cabinetry the very first one that comes to mind is cost.
Whenever you need to make a major purchase if you are budget-conscious -- by choice or by necessity, the best (I would say, only) place to start is by accumulating as much information as you can about the available possibilities. When buying cabinets, an extremely important consideration is to be sure that the measurements you are working with of the involved area(s) are accurate. You certainly do not want to learn too late that your cabinet choices and/or the resulting layout of them might have better met your needs.
Have you been shopping for kitchen cabinetry and been dissatisfied with the selection of the big box stores and import cabinet dealers? Well perhaps you should really take a close look at considering custom built kitchen cabinets as an option for your kitchen remodel project. Here I will discuss some of the advantages and disadvantages of both stock and custom cabinetry. Stock Kitchen Cabinetry What are stock kitchen cabinetry? Stock kitchen cabinets are cabinetry that are pre-built to a specific size and then resold by a cabinetry dealer. Stock cabinets are typically produced in 2 inch increments. In some basic kitchen layouts such as an L shaped kitchen you can lay cabinets out without much problem.
Installing cabinets whether in a kitchen, laundry or utility cabinets in a garage, they all have the same basic set of installation requirements. Some simple tools are required and are in most handymans tool pails. Pencils, good carpenters four foot level, tape measure, screw gun, several Quick type C clamps and a chalk line is a great start. If you have the use of a tripod with a builders level (or can rent one for a day) this will speed the work along greatly. Starting at either end of the cabinet set, make a pencil mark four feet above the floor. Now using the four foot level, transfer that mark along the wall to the other end of the cabinet run and make another pencil mark. Measure down to the floor to see if it is four feet above the floor. If it is exactly four feet, then your floor is level. If it is more than four feet then you know the floor slopes down towards that end. If you start the cabinets at that low end you will not be able to keep the cabinets level before you run "into " the floor. If you start at the four foot end that you started with, you will be able to shim the cabinets up so they all remain the same level height above the floor.