Hannah Skinner Base Cabinets January 04th, 2018 - 15:57:53
Place two C clamps in the first cabinet, lift the second cabinet into place and using the C clamps, firmly clamp the front face stile of the first cabinet to the second. The combination of the wall furring strip and the two clamps will allow you to let go and do the work of affixing the second cabinet to the wall and to each other. Making sure that the front faces are perfectly flush with each other and the heights are perfectly matched, standard practice is to pre-drill a screw hole behind the door hinge. Using drywall screws again, insert a screw in the hole making sure the screw will not penetrate through the stile of the other cabinet (too long). Place one screw behind each hinge. Now fasten the second cabinet to the wall and then release the clamps. This same scenario repeats itself until you reach the end of the cabinets. You may have spaces where a window occurs but your furring strip will assure that both sections are mounted at the same height.
Find a room in your house or the basement to assemble them. Make sure that once these cabinets are assembled that you can still get them through the door and back into the kitchen. When they are assembled, they are going to be big, bulky items to move around. Youre going to need several people to move them too. Stock Cabinets or Factory-Assembled RTA has been fully assembled by the factory and are shipped to the dealer. These are a quick assembly process. If you dont have time or talent for assembling things, or dont have an assembly area, this may be best. The dealer will provide a crew or arrange for their installation.
If your cabinets have whats called a four inch high toe kick feature, you may have the option of cutting this four inch height down to offset a small difference in the floor heights. Be careful as cutting too much can make the cabinets look squat. If the cabinets came with a detached set of toe kicks already framed, this makes leveling a great deal easier as well. Just lay out the base cabinet supports and check to see if they are level. Some shimming or minor cutting to provide perfectly sub-bases makes the base cabinet installation a snap. You need not worry whether each cabinet is level as the bases will automatically make it so.
The most important part of buying them is to measure, measure, measure! Measure the length and width of cabinet doors. If you are installing entirely cabinets, measure depth. Measure your ceiling height. Understand that newer houses tend to have higher ceilings; it may be architecturally impossible to support having tall 42 inch cabinets installed in your old kitchen. But dont worry, a solution can be had for all cabinet spaces- as long as you remember to measure properly. Why the emphasis on measurements? Consider the consequences of inaccurate measuring- crookedly hung cabinets, improperly cabinet doors that dont open properly, or worse, you purchased your kitchen cabinets online and now cannot obtain a refund.