Grace Holcomb Base Cabinets January 09th, 2018 - 10:10:33
Since stock cabinets are mass produced they can be quite affordable. Another advantage is speed, in most cases dealers have access to larger warehouses where the cabinets are stored, and you can have your stock cabinet order within a few short weeks or in some cases days. Custom Kitchen Cabinets Custom kitchen cabinets are cabinets that are built just for your kitchen layout, design taste and needs. Custom kitchen cabinetry can easily be built to fit between two walls or to match odd angles, something not possible with stock kitchen cabinets. There are many advantages with custom cabinets that can not be had with stock cabinetry. The advantages that are at the top of the list are selection.
Frameless Cabinets will have the doors meeting the other door and will have drawers against other drawers. Looking at the front of the cabinet, you will see only the door or the drawer not the cabinet box itself. 10 x 10 Standard is just that a standard measure meaning 10 foot of base cabinets and 10 foot of wall cabinets. Manufacturers have used this calculation for their standard kitchen cabinets. You can still change this to meet your footage requirements but they will be a special order instead of than the standard measurements.
Find a room in your house or the basement to assemble them. Make sure that once these cabinets are assembled that you can still get them through the door and back into the kitchen. When they are assembled, they are going to be big, bulky items to move around. Youre going to need several people to move them too. Stock Cabinets or Factory-Assembled RTA has been fully assembled by the factory and are shipped to the dealer. These are a quick assembly process. If you dont have time or talent for assembling things, or dont have an assembly area, this may be best. The dealer will provide a crew or arrange for their installation.
Installing cabinets whether in a kitchen, laundry or utility cabinets in a garage, they all have the same basic set of installation requirements. Some simple tools are required and are in most handymans tool pails. Pencils, good carpenters four foot level, tape measure, screw gun, several Quick type C clamps and a chalk line is a great start. If you have the use of a tripod with a builders level (or can rent one for a day) this will speed the work along greatly. Starting at either end of the cabinet set, make a pencil mark four feet above the floor. Now using the four foot level, transfer that mark along the wall to the other end of the cabinet run and make another pencil mark. Measure down to the floor to see if it is four feet above the floor. If it is exactly four feet, then your floor is level. If it is more than four feet then you know the floor slopes down towards that end. If you start the cabinets at that low end you will not be able to keep the cabinets level before you run "into " the floor. If you start at the four foot end that you started with, you will be able to shim the cabinets up so they all remain the same level height above the floor.