Anastasia Burns Base Cabinets January 15th, 2018 - 10:33:42
Once the sub-bases for the lower cabinets are set, I recommend that you install the upper cabinets next as it is just plain easier. Once the wider base cabinets are installed it is harder to work on the narrower upper cabinets. Just measure up from the sub-base to get the top of the cabinets, add the counter thickness, add the space you want between the lower and upper cabinets (typically eighteen inches) and make a pencil mark. That is the bottom of your upper cabinets. Since your sub-base is level, just transfer the upper cabinet mark all along the run and you will have mark to set the bottom of each upper cabinet. Next locate all the wall studs and make a vertical mark using your level that will protrude both above and below the cabinets.
Purchasing Cabinets There are different tiers on purchasing cabinets too. You save money by assembling pre-cut parts from the manufacturer. Since cabinets will be the focal point of your kitchen, you may prefer to have assembled cabinets that are installed by the dealer. The following descriptions will help you make this decision. RTA or Ready-to-Assemble is provided by the cabinet manufacturer. If the manufacturer doesnt incur the labor expense to assemble the cabinet, he will pass this savings on to you. If you are going to use RTA cabinets to cut down on the expenses, you need to find your cabinets at the beginning of your project. You need time to assemble them and ready to install after installing the flooring, painting, papering are complete.
Since stock cabinets are mass produced they can be quite affordable. Another advantage is speed, in most cases dealers have access to larger warehouses where the cabinets are stored, and you can have your stock cabinet order within a few short weeks or in some cases days. Custom Kitchen Cabinets Custom kitchen cabinets are cabinets that are built just for your kitchen layout, design taste and needs. Custom kitchen cabinetry can easily be built to fit between two walls or to match odd angles, something not possible with stock kitchen cabinets. There are many advantages with custom cabinets that can not be had with stock cabinetry. The advantages that are at the top of the list are selection.
In straight-run base-cabinets, one consideration that should be a priority is, if at all possible, to include "roll-outs" (variably called roll-out shelves, trays, etc.) factory-installed inside them; this is because "roll-outs" provide much better accessibility to items stored there (but, if your budget will only allow one roll-out per cabinet, be sure to place it on the cabinets bottom level). But, in case you happen to not be replacing perfectly fine base cabinets which do not have "roll-outs", all is not lost; that advantage can be added later via "inserts". And, if you are then unable to find "inserts" from a manufacturer, they can be self-built and installed.