Robbie Greene Base Cabinets January 09th, 2018 - 10:10:58
Because of the modifications available, these cabinets are not constructed until the order has been placed. As a result, it may take longer to receive these than stock cabinets, but not as long as custom cabinets. The cost of semi-custom cabinets depends greatly on the options you desire. The consumer has a lot of control in determining the style and layout of these cabinets. When choosing cabinets, you want to make sure that you are getting a high quality product at a fair price. Shop around until you find a cabinet retailer that is knowledgeable and experienced.
Beginning with base corner cabinets, we have: (1) the symmetrical easy reach -- this cabinet is the same length on each side of the corner and contains either shelves along its rear walls or a carousel with shelves "pie-cut" to accommodate the doors (a center hinge allows opening either the first door or both); (2) the asymmetircal easy reach -- this cabinet is a little shorter on one leg (if it includes a carousel, that diameter will be the length of the cabinets shorter leg); (3) the revolving -- this cabinet is like cabinet #1 but its doors revolve with the carousel shelves; (4) the diagonal-front -- this cabinet allows a full-circle carousel; and (5) the blind -- this cabinet looks like a straight-run cabinet but it extends into the corner along the side of an adjoining cabinet, structure, or appliance thus making its "buried" shelves accessible only from the front door (to allow better use of the "blind" corner cabinet, some manufacturers have cleverly created a cabinet with a first section which, on opening the door, pulls out and pivots to the side to expose roll-out trays which can then move forward to present their contents). Finally, there is a sink base corner cabinet that can be either an "L-shaped" cabinet to hold a butterfly sink or a diagonal-front cabinet with a regular straight-line sink -- a caveat whenever a corner sink cabinet is used: be sure that adequate standing area (for loading and unloading the dishwasher) is created by placing a 12-inch wide regular cabinet between the dishwasher and the corner cabinets side.
This way you will not be searching for a stud while standing on a ladder and balancing a cabinet. It is a few minutes work well spent. Next remove all cabinet doors marking each one is marked as to which cabinets they belong too. If you are working alone, take a piece of one by two inch furring and screw it to the wall flush with the bottom of the upper cabinet mark. You will be able to rest the cabinet on the furring while you plumb the cabinet and fasten it to the wall. Starting with the first cabinet, go ahead and screw the cabinet securely to the studs using three inch drywall screws. You can countersink them or course or use screw washers depending on what you want the final appearance to be.
On the other hand if your kitchen is country style then you might want to use traditional style cabinets. Apart from this, choosing between the custom cabinets and stock cabinets is the most difficult thing to do as it involves a lot of mind trouble. This choice can be made by keeping in mind your budget, the kitchen environment and your taste. While making the decision you should keep all the flaws and advantages in mind so that you wont end up making the wrong choice. Stock Cabinets Some people think that stock cabinets are the cabinets that can be taken away from the retailer quite easily but this is not the fact. Even though the cabinets that you can see on the store shelves are selected by you but you have to first place the order at the shop management and then wait for your required design of cabinets to be ready.