Juliet Moody Base Cabinets January 02nd, 2018 - 13:58:41
Whenever you need to make a major purchase if you are budget-conscious -- by choice or by necessity, the best (I would say, only) place to start is by accumulating as much information as you can about the available possibilities. When buying cabinets, an extremely important consideration is to be sure that the measurements you are working with of the involved area(s) are accurate. You certainly do not want to learn too late that your cabinet choices and/or the resulting layout of them might have better met your needs.
If your cabinets have whats called a four inch high toe kick feature, you may have the option of cutting this four inch height down to offset a small difference in the floor heights. Be careful as cutting too much can make the cabinets look squat. If the cabinets came with a detached set of toe kicks already framed, this makes leveling a great deal easier as well. Just lay out the base cabinet supports and check to see if they are level. Some shimming or minor cutting to provide perfectly sub-bases makes the base cabinet installation a snap. You need not worry whether each cabinet is level as the bases will automatically make it so.
Since a custom cabinet maker will be producing your new kitchen cabinets you can have them make just about any style that is imaginable. You can also have them produce cabinets that are in rare or exotic woods. You can also have a much larger selection of cabinet doors and drawer fronts. Some custom cabinet makers do opt to outsource their doors and drawer fronts, in this case they will usually have a very large catalog of doors for you to make your selection. With custom built cabinets you can select the type of hardware such as cabinet door hinges as well as drawer slides. Most are currently opting for hinges and drawer slides with the soft close feature. This is not only very popular but I wouldnt be surprise if this becomes the standard in the next few years.
Typically, stocked cabinets are offered in extremely limited sizes, and while most cabinets are offered in 3" increments, some stock cabinets may only be available in 6" increments. This is important when it comes to the overall layout of your kitchen remodel, because stock cabinets are mass-produced to the same size and specifications with no regards as to where they go. You will usually need fillers and end panels to create a finished look when using stock cabinets. The end of each cabinet that is exposed, on both the upper and the base cabinets, will need to be finished to match the front of the cabinets. This will include cutting and fitting finished panels onto the cabinet carcass itself. Keep in mind that if you are running your cabinets wall to wall, then finishing the ends is not important since the wall will hide the ends.